TEKKO TRIO 2026 03 22

When treating indoor spots, general surfaces, or cracks and crevices, what is the specified application rate?

• 1 gal. per 1,500 ft2
• 2 gal. per 1,000 ft2 ✓
• 1 fl. oz. per gal. of water
• 0.5 fl. oz. per gal. of water

Answer: For Indoor Spot, General Surface, or Crack and Crevice, the rate is 2 gal. per 1,000 ft2.

🔗 Source

When treating carpets, furniture, and pet sleeping areas, what is the required dilution rate?

• 1.0 fl. oz. per gal. of water
• 0.5 fl. oz. per gal. of water ✓
• 2.0 fl. oz. per gal. of water
• 1.0 fl. oz. per 1,500 ft2

Answer: The label specifies a dilution of 0.5 fl. oz. per gal. of water for carpet, furniture, pet sleeping areas, and throw rugs.

🔗 Source

Which of the following is a prohibited application method according to the label restrictions?

• Injecting into cracks and crevices
• Using a ULV spraying device
• Spraying into the air ✓
• Applying as a carpet shampoo

Answer: The restrictions state: 'Do not spray into the air; only spray onto the specific use sites.'

🔗 Source

What is the restriction regarding children and pets after a treatment has been applied?

• They may enter immediately if the area is ventilated
• They must stay out until the area is vacuumed
• Do not allow them into treated areas until spray has dried ✓
• They can enter after 24 hours regardless of dryness

Answer: The label states: 'After treatment, do not allow children and pets into treated areas until spray has dried.'

🔗 Source

When preparing a diluted spray solution specifically for FLEAS AND TICKS, how much Tekko Trio should be added per gallon of water?

• 0.5 fluid ounce ✓
• 1.0 fluid ounce
• 1.5 fluid ounces
• 2.0 fluid ounces

Answer: For fleas and ticks, the label instructs to add 0.5 fluid ounce Tekko Trio per gallon of water.

🔗 Source

When using an appropriate ULV spraying device to treat wall voids, how much space will the resulting 2 fl. oz. of injection solution treat?

• 1,000 cubic feet
• 1,500 cubic feet
• 1,900 cubic feet ✓
• 2,000 cubic feet

Answer: The label states that the resulting 2 fl. oz. of injection solution will be used to treat 1,900 cubic feet of space.

🔗 Source

When performing a foam application into wall, equipment, or other small structural void areas, what is the dilution rate?

• 0.5 fl. oz. per gallon of diluent
• 1.0 fl. oz. per gallon of diluent ✓
• 1.0 fl. oz. per 1,500 ft2
• 2.0 fl. oz. per gallon of diluent

Answer: For foam application, the label specifies a dilution of 1.0 fl. oz. per gallon of diluent.

🔗 Source

According to the restrictions, what must be done with pets before spraying a treatment area?

• Keep pets in a separate room during application
• Remove pets prior to spraying treatment area ✓
• Ensure pets are wearing protective gear
• Only remove pets if they are fleas or ticks carriers

Answer: The restrictions explicitly state to 'Remove pets prior to spraying treatment area.'

🔗 Source