Sumari Ant Gel Bait Offers Complete Colony Control 2026 03 22

What must be done to a surface before applying this gel bait if a repellent insecticide has been used there?

• The surface must be left alone
• The surface must be thoroughly washed ✓
• The surface must be heated to 130°F
• The surface must be covered with food-grade plastic

Answer: The label states do not apply in areas where repellent insecticides have been or will be used without thoroughly washing the surface.

🔗 Source

Where is a strictly prohibited application site for this product regarding aircraft?

• In the passenger cabin
• In the cargo hold
• In cockpit areas ✓
• In the lavatories

Answer: The restrictions state: 'DO NOT APPLY ANY BAIT IN COCKPIT AREAS OF AIRCRAFT.'

🔗 Source

In which of the following locations is the bait permitted for use in a food handling establishment?

• On food preparation surfaces
• On kitchen utensils
• In nonfood areas like garbage rooms or lavatories ✓
• On food containers

Answer: The label specifies use in nonfood areas such as garbage rooms, lavatories, and offices, but prohibits use on food preparation surfaces or utensils.

🔗 Source

Which of the following pests is NOT a target pest for Sumari Ant Gel Bait?

• Carpenter ants ✓
• General ants
• Ants in residential areas
• Ants in industrial areas

Answer: The label explicitly states the product is for ants excluding fire ants and carpenter ants.

🔗 Source

According to the label, what is the only approved application method for this product?

• Broadcast spraying
• Mist application
• Spot and crack and crevice application ✓
• Drenching and soaking

Answer: The restrictions state: 'Only for spot and crack and crevice application.'

🔗 Source

When applying the bait to food handling areas, how should the dispenser tip be positioned?

• On the surface of the food preparation area
• Approximately 1/2 inch into cracks and crevices ✓
• Spread in a wide line across the floor
• Directly onto food containers

Answer: The label instructions for food handling areas state to place the bait dispenser tip approximately 1/2 inch into cracks.

🔗 Source

What is a required action if the gel bait contacts an exposed surface?

• Apply more gel to cover the area
• Leave it to dry naturally
• Remove the gel and wash the exposed surfaces ✓
• Cover the surface with a repellent insecticide

Answer: The label states that if gel bait contacts an exposed surface, you must remove the gel and wash the exposed surfaces.

🔗 Source

Under what temperature condition should the bait NOT be applied to surfaces?

• Below 32°F
• Exceeding 120-130°F ✓
• Between 70-90°F
• Exactly 100°F

Answer: The label warns not to apply to surfaces where the temperature exceeds 120-130°F because the bait could liquefy.

🔗 Source