Premise 75 WP Termiticide

Which of the following is a specific restriction regarding mixing Premise 75 WP?

• Do not use with products or in a tank that may contain boron or release free chlorine ✓
• Do not mix with water temperatures below 50 degrees
• Do not mix with any other liquid termiticide
• Do not use in tanks made of plastic

Answer: The label explicitly prohibits use with products or in tanks that may contain boron or release free chlorine.

According to the label, when should a 0.1% dilution be used instead of a 0.05% dilution?

• Where severe or persistent infestations occur ✓
• When applying to concrete slabs
• When using cooler water temperatures
• When applying to hollow masonry units

Answer: The label states a 0.1% dilution may be used where severe or persistent infestations occur.

When applying to voids in hollow masonry units, what is the required rate?

• 2 gallons per 10 linear feet of wall ✓
• 1 gallon per 10 square feet
• 4 gallons per 10 linear feet
• 1.5 gallons per 10 square feet

Answer: The label specifies a rate of 2 gallons per 10 linear feet of wall for voids in hollow masonry units.

If soil conditions will not accept the standard 4 gallons per 10 linear feet, what alternative application method is permitted?

• Apply 2 gallons of solution at a 0.1% concentration per 10 linear feet ✓
• Apply 8 gallons of solution at a 0.05% concentration per 10 linear feet
• Apply 2 gallons of solution at a 0.05% concentration per 10 linear feet
• Apply 4 gallons of solution at a 0.2% concentration per 10 linear feet

Answer: The label allows applying twice the concentration in 2 gallons of solution per 10 linear feet if soil won't accept 4 gallons.

What is the primary target pest for Premise 75 WP Termiticide according to the label?

• Subterranean termite ✓
• Carpenter ant
• Termite larvae only
• All wood-destroying insects

Answer: The label specifically lists subterranean termite as the target pest.

What effect does cooler water temperature have during the mixing process?

• It increases the time needed for the inner packet to dissolve completely ✓
• It prevents the dilution from reaching 0.1%
• It requires a higher concentration of product
• It makes the solution more effective for soil penetration

Answer: The label notes that cooler water temperatures increase the time needed for the inner packet to dissolve.

Where is Premise 75 WP Termiticide intended to be applied?

• Outdoor ✓
• Indoor
• Both Indoor and Outdoor
• Greenhouse only

Answer: All listed application sites and locations in the provided facts are categorized as Outdoor.

When treating typical control situations for subterranean termites in soil, what dilution should generally be used?

• 0.05% ✓
• 0.1%
• 0.5%
• 1.0%

Answer: The label states that generally a 0.05% dilution is used for typical control situations.