MOSQUITO MIST ULTRA 2026 03 22

Practice 8 MOSQUITO MIST ULTRA 2026 03 22 exam questions with instant feedback and cited explanations.

Practice ExamsChemicals › MOSQUITO MIST ULTRA 2026 03 22
Start practice — 8 questions →

Sample questions

Which of the following is a permitted outdoor site for treating resting or flying adult mosquitoes?

Answer: Tire piles are specifically listed as an outdoor site where adult mosquitoes occur or find harborage.

🔗 Source

When treating mosquitoes on resting or aggregation surfaces, what is the correct mixing ratio?

Answer: The label specifies mixing 0.126 oz. (3.73 ml) in one gallon of water for resting or aggregation surfaces.

🔗 Source

When applying to resting or aggregation surfaces, approximately how much area should the spray dampen?

Answer: The label notes that applying 0.126 oz. in one gallon of water should dampen approximately 700-750 square feet of treated area.

🔗 Source

To achieve an application rate of 0.0035 pounds of permethrin per acre using a backpack or handheld sprayer, what dilution must be used?

Answer: To apply 0.0035 pounds of permethrin per acre, the label requires 1 part Mosquito Mist Ultra with 5 parts of diluent.

🔗 Source

When using thermal aerosol application, what is the requirement for the spray droplets?

Answer: The label requires that 90% of the spray is contained in droplets smaller than 48 microns (Dv 0.9 < 48 µm) for thermal aerosol application.

🔗 Source

Which pests are targeted when applying the product to indoor harborage areas like utility tunnels, sewers, and basements?

Answer: For indoor harborage areas such as utility tunnels and sewers, the product targets mosquitoes, biting flies, and biting midges.

🔗 Source

When using low pressure hand sprayers, hydraulic sprayers, or ground ULV equipment for barrier applications, what is the restriction regarding water bodies?

Answer: The restrictions state not to apply within 100 feet (30 meters) of lakes and streams when using these specific application methods.

🔗 Source

What is the minimum temperature requirement for conducting all applications of this product?

Answer: The label states all applications should be conducted when temperatures are greater than 50°F.

🔗 Source

← All practice exams