Double Nickel 55

Which of the following is a stated restriction for using Double Nickel 55?

• It cannot be used on leafy vegetables
• It cannot be applied when weather favors drift or runoff ✓
• It cannot be used in combination with chemical fungicides
• It cannot be applied via chemigation

Answer: The label explicitly states: 'Do not apply when weather conditions favor drift or runoff.'

🔗 Source

When mixing Double Nickel 55, what is the required pH range for the water used?

• A neutral pH of 6 to 8 ✓
• A highly acidic pH of 3 to 5
• A highly alkaline pH of 9 to 11
• A pH of exactly 7.0 only

Answer: The label instructions state to use water with a neutral pH of 6 to 8.

🔗 Source

Under what condition should a technician use a NIOSH-approved particulate filter?

• When applying via aerial fixed or rotary wing aircraft
• When mixing the product in highly acidic water
• When using certain spray equipment ✓
• When applying the product in intertidal areas

Answer: The label states that if using certain spray equipment, a NIOSH-approved particulate filter may be required.

🔗 Source

According to the label, where is Double Nickel 55 intended to be applied?

• Indoor greenhouse environments only
• Outdoor plant surfaces including roots and leaves ✓
• Directly into standing surface water
• Only in intertidal areas below the mean high water mark

Answer: The label specifies outdoor application to roots, leaves, and other plant surfaces, while explicitly prohibiting application to surface water or intertidal areas.

🔗 Source

Which of the following best describes the primary target of Double Nickel 55?

• Fungal and bacterial plant diseases ✓
• Insects and mites on agricultural crops
• Weeds and invasive plant species
• Soil-borne nematodes and larvae

Answer: The label states the product provides broad-spectrum preventative control against various fungal and bacterial plant diseases.

🔗 Source

What must a technician do with the spray mix after preparation?

• Allow the mix to stand overnight for better activation
• Store in a cool, dark place for 24 hours
• Apply immediately after mixing ✓
• Dilute with alkaline water to stabilize

Answer: The timing/weather instructions state to apply immediately after mixing and do not allow the spray mix to stand overnight.

🔗 Source

Which of these is a mandatory requirement for handling the product according to the PPE section?

• Full-body chemical suit and goggles
• Long-sleeved shirt, long pants, and waterproof gloves ✓
• Nitrile gloves and a face shield only
• Rubber boots and a heavy-duty apron

Answer: The label requires long-sleeved shirts, long pants, waterproof gloves, and shoes plus socks for handling.

🔗 Source

What is the Re-entry Interval (REI) for this product?

• 4 hours ✓
• 12 hours
• 24 hours
• 48 hours

Answer: The label specifies a re-entry interval (rei_hours) of 4.

🔗 Source