DiPel PRO DF Biological Insecticide

When applying DiPel PRO DF as a surface treatment for Almond Moth in grain, how deep should the mixture be mixed?

• The top 1 inch
• The top 4 inches ✓
• The top 8 inches
• The entire depth of the grain

Answer: The label states to apply 1/2 lb. in 5-10 gal. of water per 500 sq. ft. and mix into the top 4 inches.

🔗 Source

If treating light to moderate populations of newly hatched Armyworms, how often should treatments be repeated?

• Every 24 hours
• At 4 to 5-day intervals ✓
• Once every two weeks
• Only when populations increase

Answer: For light to moderate populations of newly hatched worms, the label instructs to repeat treatments at 4 to 5-day intervals.

🔗 Source

When applying DiPel PRO DF to control Loopers in Watercress, what is a specific site requirement?

• Apply only during high tide
• Spray only when there is no standing water in the bed ✓
• Ensure the bed is completely flooded
• Apply only to the top 4 inches of water

Answer: The label notes for Looper in Watercress state to spray only when there is no standing water in the bed.

🔗 Source

What is the specific condition required for Tobacco at the time of application for Tobacco Moth control?

• It must be completely dry to prevent mold
• It must be submerged in water
• It should have just enough moisture to be handled without shattering ✓
• It must be heated to a specific temperature

Answer: The timing/weather notes state that tobacco should have just enough moisture to be handled without shattering at the time of application.

🔗 Source

Which of the following pests is NOT controlled by DiPel PRO DF according to the label?

• Looper
• Armyworms
• Weevils ✓
• Diamondback Moth

Answer: The label restrictions explicitly state that DiPel DF will not control weevils or other beetles.

🔗 Source

When treating Tobacco Moth in storage barns, what is the required mixing ratio?

• 1/2 oz. in 2-1/2 gallons of water ✓
• 1/2 lb. in 100 gallons of water
• 0.2 oz. in 1 quart of water
• 3-3/4 lbs. in 5 gallons of water

Answer: Under the mixing section for Tobacco Moth (Storage Barns), the label calls for 1/2 oz. (6 tsps.) per 2-1/2 gallons of water.

🔗 Source

When applying the mixture for Indian Meal Moth or Almond Moth (3-3/4 lbs. in 5 gallons of water), what is a critical handling instruction?

• Pre-mix at least 48 hours in advance
• Keep the spray suspension agitated during application ✓
• Apply only in temperatures above 90 degrees
• Use high-pressure nozzles only

Answer: The mixing instructions state to keep the spray suspension agitated during application and use appropriate pressures/nozzles.

🔗 Source

For indoor control of Indian Meal Moth or Almond Moth in grains, what is the application rate for all states except California?

• 1/4 lb./ton
• 1/2 lb./100 bu
• 3/8 lb./100 bu ✓
• 1/2 lb. per 500 sq. ft.

Answer: The label specifies a rate of 3/8 lb./100 bu for Indian Meal Moth and Almond Moth in various grains/seeds for all states except California.

🔗 Source