DeBug Tres 2026 03 22

What is the required method for delivering the product to the correct depth when treating Turf for Insects and Worms?

• Apply only to the surface of the leaves.
• Use sprinklers or other means to push material to 1/4 inch - 1/2 inch below ground level. ✓
• Apply via chemigation only.
• Drench the area with 50 gallons of water per 1,000 sq. ft.

Answer: For Insect and Worm control on Turf, the label instructs to use sprinklers or other means to push the material to 1/4 inch - 1/2 inch below ground level.

🔗 Source

Under what weather condition should you avoid applying DeBug Tres?

• When it is raining heavily.
• When wind speed favors drift beyond the intended treatment area. ✓
• When temperatures are above 90 degrees.
• When there is no sunlight available.

Answer: The restrictions state: 'Do not apply when wind speed favors drift beyond the area intended for treatment.'

🔗 Source

When targeting Nematodes on Ornamentals and Turf, what is the recommended application rate per 1,000 sq. ft.?

• 0.3 to 1 FL. OZ.
• 8 to 22.5 FL. OZ. ✓
• 12 to 22.5 FL. OZ.
• 1.25 FL. OZ.

Answer: The label states for Nematode control on Ornamentals and Turf, the rate is 8 to 22.5 FL. OZ. per 1,000 sq. ft.

🔗 Source

According to the label, what should a technician do with mixed material?

• Store in a cool, dry place for up to 24 hours.
• Dilute further if the infestation is high.
• DO NOT SAVE MIXED MATERIAL. ✓
• Re-use for the next scheduled application.

Answer: The restrictions section explicitly states: 'DO NOT SAVE MIXED MATERIAL.'

🔗 Source

Which pest is NOT listed as a target for DeBug Tres?

• Chinch bugs
• Spider Mites
• Aphids
• Termites ✓

Answer: While many insects and worms are listed (Chinch bugs, Spider Mites, Aphids), Termites are not mentioned in the label facts.

🔗 Source

If using a supply tank for Chemigation, what is the correct dilution rate?

• 1.25 gallons per 500 gallons of water ✓
• 8 to 22.5 gallons per 500 gallons of water
• 0.3 gallons per 100 gallons of water
• 12 gallons per 1,000 gallons of water

Answer: The mixing notes for Chemigation state to dilute the product at the rate of 1.25 gallons per 500 gallons of water.

🔗 Source

When applying DeBug Tres for Insect and Worm control on Turf, what specific pH level should the mixture achieve using a buffer?

• 7.0
• 4.5
• 5.5 ✓
• 6.5

Answer: The label instructions for Insect and Worm control specify to ensure that the pH of the mixture is around 5.5 by using a buffer.

🔗 Source

Which of the following is a recommended time of day to spray DeBug Tres?

• Midday when sun is highest
• Early morning, late afternoon, or evenings ✓
• Only during high wind periods
• At noon to ensure maximum evaporation

Answer: The timing/weather section states to spray DeBug Tres in the early morning or late afternoon or evenings.

🔗 Source