CYPER TC II

What is the specified finished strength range when mixing Cyper TC with water?

• 0.10% to 0.50%
• 0.25% to 1.00% ✓
• 1.00% to 5.00%
• 5.00% to 10.00%

Answer: The mixing and dilution section states: 'finished_strength: 0.25% to 1.00%';

🔗 Source

Which target pest is CYPER TC II primarily designed to control?

• Ants and cockroaches
• Subterranean termites (including Eastern, Western, and Formosan species) ✓
• Fleas and ticks
• Silverfish and centipedes

Answer: The description states: 'It is primarily designed for the control of subterranean termites, including Eastern, Western, and Formosan species.'

🔗 Source

When applying CYPER TC II for preconstruction termite control, where should the product be applied to the soil?

• In motor housings and junction boxes
• Around foundations, footings, and crawl spaces ✓
• In classrooms or institutions with occupants present
• As a space spray in living areas

Answer: The label states: 'For preconstruction, it is applied to the soil around foundations, footings, and crawl spaces.'

🔗 Source

Under which weather conditions is it prohibited to apply CYPER TC II?

• When wind speeds exceed 10 mph at the nozzle end ✓
• When temperatures are above 90 degrees Fahrenheit
• When humidity is above 80%
• When wind speeds are between 15 and 20 mph

Answer: The label states: 'Do not apply when wind speeds exceed 10 mph at nozzle end.'

🔗 Source

What is the required mixing protocol for Cyper TC when diluting with water in a tank?

• Agitate for 10-15 minutes until fully dissolved
• Mix and allow circulation for 2-3 minutes ✓
• Mix and allow to sit for 1 hour before use
• Shake vigorously for 5 minutes

Answer: The label states: 'Mix with water in a tank; allow circulation for 2-3 minutes.'

🔗 Source

When is application of the product prohibited based on soil conditions?

• When soil is dry and dusty
• When soil is water-saturated or frozen ✓
• When soil temperature is below 50 degrees
• When soil has been treated within the last 30 days

Answer: The label states: 'Do not apply to water-saturated or frozen soil.'

🔗 Source

Which of the following is a required component of the Personal Protective Equipment (PPE) when handling this product?

• Nitrile gloves
• Chemical-resistant gloves made of barrier laminate or viton ✓
• Safety goggles and a respirator
• Waterproof rain coat and rubber boots

Answer: The PPE section specifies: 'chemical-resistant gloves (barrier laminate or viton)'.

🔗 Source

According to the label, which of these is a prohibited application site for this product?

• Soil around footings
• Crawl spaces
• Conduits, motor housings, or junction boxes ✓
• Subslab voids via injection

Answer: The use restrictions state: 'Do not use in conduits, motor housings, junction box, or electrical equipment.'

🔗 Source