Cimarron Plus 2026 03 22

Which of the following is a target pest listed for Cimarron Plus 2026 03 22?

• Muscadine (wild grape) ✓
• Dandelion
• Crabgrass
• Bermuda grass

Answer: The label explicitly lists Muscadine (wild grape) as a target pest.

🔗 Source

According to the label restrictions, what must you avoid when using spray additives?

• Using additives that increase the volume of the spray
• Using additives that reduce the pH of the spray solution to below 3.0 ✓
• Using additives that contain surfactants
• Using additives that increase the concentration of chlorsulfuron

Answer: The label states: DO NOT use CIMARRON® PLUS HERBICIDE with spray additives that reduce the pH of the spray solution to below 3.0.

🔗 Source

Which component of Cimarron Plus 2026 03 22 is identified as a restricted use pesticide?

• Metsulfuron-methyl
• Chlorsulfuron
• Picloram ✓
• Surfactant

Answer: The label explicitly states that Picloram is a restricted use pesticide.

🔗 Source

When performing a Spotgun Basal Soil Treatment for multiflora rose, where should the product be applied?

• On the leaves of the canopy
• Soil within 2 feet of the stem union ✓
• Directly into the center of the flower
• On the bark of the main trunk only

Answer: The label specifies applying the Spotgun Basal Soil Treatment to the soil within 2 feet of the stem union.

🔗 Source

What is the required application rate for weeds in non-crop areas when using a spot treatment?

• 1 gram per one gallon of water along with a surfactant ✓
• 5 to 10 ounces per 100 gallons of water
• 1.25 ounces per 100 gallons of water
• 4 milliliters per 2 feet of canopy

Answer: For weeds in non-crop areas, the label specifies a rate of 1 gram per one gallon of water along with a surfactant.

🔗 Source

To avoid product degradation, within what timeframe should the CIMARRON® PLUS HERBICIDE spray mixture be applied?

• Within 12 hours of mixing
• Within 24 hours of mixing ✓
• Within 48 hours of mixing
• Immediately upon mixing

Answer: The label instructs to apply the spray mixture within 24 hours of mixing to avoid product degradation.

🔗 Source

When treating deciduous species, what is the recommended timing for foliar application?

• During the winter dormancy period
• From full leaf expansion in the spring until the development of full fall coloration ✓
• Only during the peak of summer heat
• During the first frost of autumn

Answer: For deciduous species, the label recommends application from full leaf expansion in the spring until full fall coloration.

🔗 Source

What is the specified spray volume requirement for aerial applications?

• A minimum of 15 gallons per acre ✓
• A minimum of 40 gallons per acre
• Exactly 100 gallons per acre
• At least 1 gallon per 100 gallons of water

Answer: The label states that aerial applications use a minimum of 15 gallons per acre spray volume.

🔗 Source