AquashadePlus

Which of the following is NOT a target pest for AquashadePlus?

• Bluegreen algae
• Submersed plants
• Filamentous green algae
• Mosquito larvae ✓

Answer: The label lists submersed plants, algae blooms, filamentous green algae, and bluegreen algae as targets, but does not mention mosquito larvae.

🔗 Source

What effect might active chlorine residuals, such as in a swimming pool, have on the product?

• The color and effectiveness may be lost ✓
• The product will become more concentrated
• The product will turn a bright red color
• The product will increase the water depth

Answer: The label notes that color and effectiveness may be lost in waters with active chlorine residuals.

🔗 Source

In which type of environment is AquashadePlus most effective?

• Water depths of less than 2 feet ✓
• Water depths exceeding 10 feet
• Deep reservoirs and oceans
• High-flow river currents

Answer: The label states the product is most effective in water depths of less than 2 feet.

🔗 Source

How should AquashadePlus be applied for the best results regarding timing?

• As a pre-emergent before the growing season ✓
• During the peak of the summer bloom
• Only after the plants have died
• In the middle of the autumn harvest

Answer: For best results, the label recommends applying it as a pre-emergent before the growing season.

🔗 Source

What is a potential risk to shoreline non-target plants if the product is applied directly to them?

• They may suffer contact burn ✓
• They may grow faster
• They may turn aqua-blue
• They may become resistant to algae

Answer: The restrictions state that shoreline non-target plants may suffer contact burn if applied directly to them.

🔗 Source

According to the label, where should AquashadePlus NEVER be applied?

• Water used for human consumption ✓
• Golf course ponds
• Manmade lakes
• Water turfs

Answer: The restrictions section explicitly states: 'Do not apply to water used for human consumption.'

🔗 Source

What is the recommended application rate for AquashadePlus?

• 0.5-2.0 ppm total dye ✓
• 5.0-20.0 ppm total dye
• 0.5-2.0 gallons per acre
• 10-50 ppm total dye

Answer: The application rate listed in the label is 0.5-2.0 ppm total dye.

🔗 Source

Which method can be used to achieve quicker dispersion of the product?

• Using aeration devices like fountains ✓
• Mixing it with heavy silt
• Applying it only at midnight
• Injecting it into the lake bed

Answer: The label states the product can be used with aeration devices like fountains for quicker dispersion.

🔗 Source