Agri-Mycin 50

What is the required Personal Protective Equipment (PPE) if mists are present during application?

• A dust mask only
• A NIOSH-approved respirator with N, R, or P filter ✓
• A full-face shield and heavy apron
• A chemical-resistant suit and goggles

Answer: The label requires a NIOSH-approved respirator with N, R, or P filter if mists are present.

🔗 Source

What is the required concentration range for general dilution of Agri-Mycin 50?

• 10-50 ppm
• 50-200 ppm ✓
• 100-300 ppm
• 200-500 ppm

Answer: The mixing section states users must follow dilution rates based on a desired concentration of 50 to 200 ppm.

🔗 Source

When treating Coleys for bacterial blight, when should the first spray be applied?

• During the bloom stage
• After the seedlings have transplanted
• When seedlings are in the 2-leaf stage ✓
• At 20-30% bloom

Answer: For Coleys, the label says to apply the first spray when seedlings are in the 2-leaf stage.

🔗 Source

What is the Restricted-Entry Interval (REI) for Agri-Mycin 50?

• 4 hours
• 12 hours ✓
• 24 hours
• 48 hours

Answer: The product has a restricted-entry interval (REI) of 12 hours.

🔗 Source

When treating apples for fine blight, what is the recommended timing for the first application?

• At the 2-leaf stage
• Immediately after petal fall
• At 20-30% bloom ✓
• Weekly during the growing season

Answer: For apple fine blight, the label instructs to make the first application at 20-30% bloom.

🔗 Source

Which of the following diseases is Agri-Mycin 50 specifically listed to control in tobacco crops?

• Soft rot and blackleg
• Wildfire and blue mold ✓
• Fine blight
• Bacterial wilt

Answer: The label states that for tobacco, the product is used to control Wildfire and Blue Mold.

🔗 Source

According to the label restrictions, how should Agri-Mycin 50 be applied regarding irrigation?

• It can be applied via any irrigation system
• It should only be applied through drip irrigation
• Do not apply to any type of irrigation system ✓
• It must be mixed into the irrigation water

Answer: The restrictions explicitly state: 'Do not apply to any type of irrigation system.'

🔗 Source

For ornamental gardens and trees, what is the recommended application rate for fine blight?

• 2-3 oz ✓
• 8-16 oz
• 5.1/5 oz per 100 gal
• 200 ppm

Answer: The application rate for fine blight in Ornamental Garden/Trees is 2-3 oz.

🔗 Source